Although they serve the same purpose, heat pumps are a lot different from other heating systems like furnaces and boilers. Here are some of the best heat pump tips from heat pump repair services for better efficiency and to reduce the bills.

Adjust the Heat Pump

Heat pumps used in cold weather usually show good efficiency and so their heating thing perfectly throughout the season. They can help you maintain a good warm temperature inside the home. When you’re using the heat pump and central system in combination, you can adjust the heat pump to a comfortable heat level, and keep the central system a bit lower than that to get the best results. After doing this, you can forget about your heat pump for the rest of the season.

If these settings don’t seem to work properly, then you can use other combinations to achieve the desired results.

Customize the Heating Zones

Many people use the central heating system and heat pump in combination. In this case, you’ll need to turn down, or of that part/zone of the central heating system where you’re using the heat pump. If the central heating system in your home isn’t already zoned, you can consider closing the dampers and radiators in the room where the heat pump is located. However, if you start to have an area of your house too cold due to this, you can turn up the heat on your central heating system till that area is nicely warmed up.

Set the Temperature Wisely

To get the most out of your heat pump and make it energy efficient, you should set the temperature to a comfortable level according to your preferences. Just because the heat pumps are installed at more height than your typical thermostat, you’ll need to use a slightly high-temperature setting than you’re used to.

Don’t Use the Auto Mode

Avoid using the auto mode on your heat pump. Instead, manually set the heat pump to “heat” settings in the winter and to “cold” settings in the summer. Using the auto mode isn’t recommended because it can cause the pump to produce heat on a cold summer night and heat on a hot winter day.

Avoid Making Any Changes After Initial Setup

Once you’ve set up your heat pump by installing it in a reasonable place and have set the thermostat, you should avoid making any drastic changes to the set temperature setting of the heat pump. Remember that your heat pump works to maintain a steady temperature, and it’ll start using a lot more energy to readjust the temperature if you make any changes. Don’t even turn the heat pump off if you’re away for some time during the day or night.

Set the Fan Setting Precisely

Initially, you can use the “auto” setting for your fan, if that doesn’t seem to help your cause, then you can tweak the settings so that the fan spreads the heat throughout the usage area. Try not to use the maximum settings right away, this way you can save some energy.

Also, you can adjust the flow of heat to get the desired results. Usually, the heat is best directed downwards.

Choose the Right Type Of Air Flow

You can use the vanes of your heat pump to get the heat or cold air wherever you need it. Usually, warm air should be directed directly towards the floor, or away from the people sitting in the room. And cold air should be directed upwards, or directly towards the people sitting in the room. You can use other locations too according to your own needs.

Maintain the Heat Pump Properly

To keep your heat pump working properly, you’ll have to do heat pump repairs Arlington VA regularly or at-least, as soon as the need arise. For cleaning, you can start by cleaning the dust filters on a regular basis. Keep checking these filters and vacuum/rinse them when you start seeing the dust accumulating on them. Also, keep checking the outdoor unit of your heat pump and clean it on a regular basis too to get any debris or other things out of it. To clean the outdoor unit, you can use water to properly do the maintenance work, and also save a lot of your time.